Publicité
WIRING DIAGRAM
CORRECT
INSTRUCTIONS SPECIFIC FOR CANADIAN
Do not obstruct the space under the heater and do
not obstruct the combustion air openings.
Refer to the chimney manufacturer's instructions
for
disassembling
transportation of a transportable building.
The parts or materials to be employed for ember
protectors and the minimum areas to be covered
and their relation to the space heater, as well as
the notice: "In Canada, to comply with CSA B365,
Installation Code for Solid-Fuel-Burning Appliances
and Equipment, any combustible covering beneath
the appliance and/or within the area extending
horizontally at least 450 mm (18 in) beyond the
appliance on any side equipped with a door, and at
least 200 mm (8 in) beyond the appliance on other
sides, shall be protected by a continuous, durable,
WRONG
INSTALLATIONS
the
chimney/venting
Ensure the wires are connected
to the bottom two prongs of the
hopper switch as shown.
non-combustible pad that will provide ember
protection. The 450 mm (18 in) ember protection
required on any side with a door shall extend for
the full width of the appliance plus the 200 mm (8
for
in) required on each side of the appliance without a
door. Where an appliance is installed less than 200
mm (8 in) from a wall, the ember pad need only
extend to the base of the wall. An ember pad shall
not be placed on top of a carpet unless the pad is
structurally supported to prevent displacement
and distortion.
If this appliance is installed in a transportable
building, removal of the chimney/venting is
required for transportation of the building.
DO NOT INSTALL IN AN ALCOVE
DO NOT INSTALL IN ANY FIREPLACE
19
© 2023 United States Stove Company
Publicité
