Publicité
Liens rapides
Save these instructions. This manual will help you to obtain
efficient, dependable service from the heater, and enable
you to order repair parts correctly. Keep in a safe place for
If this heater is not properly installed, a house fire may result.
For your safety, follow the installation instructions. Never
use make-shift compromises during the installation of this
heater. Contact local building or fire officials about permits,
restrictions and installation requirements in your area.
Please read this entire manual before you install or use your
new room heater. Failure to follow instructions may result in
property damage, bodily injury, or even death. Improper
Installation Could Void Your Warranty!
MODEL: AW2020E
future reference.
SAFETY NOTICE:
CAUTION!
United States Stove Company
PO Box 151, 227 Industrial Park Rd.,
South Pittsburg, TN 37380
PH: (800) 750-2723
www.usstove.com
Report Number: F19-476
Certified to: UL 1482-2011 (R2015) and
ULC-S627-00 (R2016)
Mobile home approved (U.S. ONLY)
U.S. Environmental Protection Agency
Ce produit peut vous exposer à des agents chimiques, y compris au monoxyde de
Certified to comply with 2020 particulate
carbone, lesquels sont reconnus dans l'État de la Californie comme causant le cancer et
emissions standards.
des malformations congénitales ou autres dommages au fœtus. Pour obtenir plus de
renseignements, veuillez consulter le site www.P65warnings.ca.gov
CALIFORNIA PROPOSITION 65 WARNING:
This product can expose you to chemicals including carbon monoxide, which
is known to the State of California to cause cancer, birth defects and/or other
reproductive harm. For more information, go to www.P65warnings.ca.gov
R
853576B-4203i
Publicité
Manuels Connexes pour Ashley AW2020E-BL
Sommaire des Matières pour Ashley AW2020E-BL
- Page 1 MODEL: AW2020E Save these instructions. This manual will help you to obtain efficient, dependable service from the heater, and enable you to order repair parts correctly. Keep in a safe place for future reference. Report Number: F19-476 SAFETY NOTICE: Certified to: UL 1482-2011 (R2015) and If this heater is not properly installed, a house fire may result.
- Page 2 The instructions pertaining to the installation of your wood stove comply with UL-1482 (R2015) and ULC-S627 standards. This manual describes the installation and operation of the Ashley, AW2020E wood heater. This heater meets the 2020 U.S. Environmental Protection Agency’s cordwood emission limits for wood heaters sold after May 15, 2020.
-
Page 3: Blower Assembly
Assembly Instructions TOOLS AND MATERIALS NEEDED FOR INSTALLATION You will need a drill with a 1/8” bit to install sheet metal screws into connector pipe. A 5/16” socket/wrench or screw driver to install the room air deflector, and blower assembly described. A 1/2” socket/wrench to install flue collar. - Page 4 Installation SAFETY NOTICE • IF THIS STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOW THE INSTALLATION INSTRUCTIONS. • CONSULT YOUR MUNICIPAL BUILDING DEPARTMENT OR FIRE OFFICIALS ABOUT PERMITS, RESTRICTIONS AND INSTALLATIONS REQUIREMENTS IN YOUR AREA. •...
-
Page 5: Clearances To Combustibles
CLEARANCES TO COMBUSTIBLES It is of utmost importance that the clearances to combustible materials be strictly adhered to during installation of the stove. Refer to the tables below. Single Wall Pipe (Double Wall Pipe) 15 (12) 381 (305) 18 (18) 458 (458) 19 (16) 483 (407) - Page 6 For use in MOBILE HOMES (U.S. installations ONLY): • WARNING! DO NOT INSTALL IN SLEEPING ROOM. • CAUTION! THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL, AND CEILING/ROOF MUST BE MAINTAINED. • INSTALL IN ACCORDANCE WITH 24 CFR, PART 3280 (HUD). •...
- Page 7 CHIMNEY CONNECTOR (STOVE PIPE) The chimney connector and chimney must have the same diameter as the stove outlet (6”). If this is not the case, we recommend you contact your dealer to ensure there will be no problem with the draft.
-
Page 8: Masonry Chimney
FACTORY BUILT CHIMNEY When a metal prefabricated chimney is used, the manufacturer’s installation instructions must be followed. You must also purchase (from the same manufacturer) and install the ceiling support package or wall pass-through and “T” section package, firestops (where needed), insulation shield, roof flashing, chimney cap, etc. Maintain proper clearance to the structure as recommended by the manufacturer. - Page 9 COMBUSTIBLE WALL CHIMNEY CONNECTOR PASS-THROUGHS METHOD A - 12” (304.8 mm) Clearance to Combustible Wall Le dégagement minimum de la cheminée à la brique et les Member: Using a minimum thickness 3.5” (89 mm) brick matériaux combustibles est de 5 cm (2 po) (50,8 mm) and a 5/8”...
- Page 10 Operation WOOD STOVE UTILIZATION The operation of this wood heater in a manner inconsistent with the owner’s manual will void your warranty and is also against federal regulations. This heater is designed to burn natural wood only. Higher efficiencies and lower emissions generally result when burning air dried seasoned hardwoods, as compared to softwoods or too green or freshly cut hardwoods.
-
Page 11: Operational Tips
It is EXTREMELY IMPORTANT to use DRY WOOD only in your wood stove. The wood should have dried for 9 to 15 months, such that the humidity content (in weight) is reduced below 20% of the weight of the log. It is very important to keep in mind that even if the wood has been cut for one, two or even more years, it is not necessarily dry, if it has been stored in poor conditions. - Page 12 negative pressure in the house. If such is the case, open a window slightly near the stove and twist together a few sheets of newspaper into a torch. Light up this paper torch and hold it as close as possible to the mouth of the pipe inside the combustion chamber to warm up the chimney.
-
Page 13: Ash Disposal
RELOADING Once you have obtained a good bed of embers, you should reload the unit. To do so, open the air controls to maximum a few seconds before opening the stove’s door. Then proceed by opening the door very slowly; open it one or two inches for 5 to 10 seconds, before opening it completely to increase the draft and thus eliminate the smoke which is stagnant in a state of slow combustion in the stove. - Page 14 Maintenance Your wood stove is a high-efficiency stove and therefore requires little maintenance. It is important to perform a visual inspection of the stove every time it is emptied, to ensure that no parts have been damaged, in which case repairs must be performed immediately. Inspect and clean the chimney and connector pipe periodically for creosote build-up or obstructions.
-
Page 15: Repair Parts
Rear Ashpan (AW2020E-BP) 29068 Pedestal (AW2020E-BP) 29065 Pedestal Front (AW2020E-BP) 610922 Pedestal Weldment (AW2020E-BP) 610925 Ashpan Housing (AW2020E-BL) 40566 Cast Iron Leg (AW2020E-BL) 29071 Ash Pan 891137 Brushed Nickel Handle 610927 Damper Slide Weld 610066 Slide Retainer Weld 86954 Damper Rod... - Page 16 Repair Parts Part No. Description Qty. 88316 Kao Wool Blanket 88146 Ceramic Fiber Board 86953 Secondary Air Tube (Ø1/8) 86952 Secondary Air Tube (Ø11/64) 29039 Brick Retainer (left) 29040 Brick Retainer (right) 40561 Ash Plug 24103A Half Pumice Firebrick (4-1/2 X 4-1/2) 891414A Half Firebrick 89066A...
- Page 17 Notes...
- Page 18 Notes...
-
Page 19: Service Record
Service Record It is recommended that your heating system is serviced regularly and that the appropriate Service Interval Record is completed. SERVICE PROVIDER Before completing the appropriate Service Record below, please ensure you have carried out the service as described in the manufacturer’s instructions. Always use the manufacturer's specified spare part when replacement is necessary. - Page 20 HOW TO ORDER REPAIR PARTS / COMMANDE DE PIÈCES DE RECHANGE THIS MANUAL WILL HELP TO OBTAIN EFFICIENT, DEPENDABLE SERVICE FROM THE HEATER, AND WILL ENABLE THE CORRECT REPAIR PARTS TO BE ORDERED. KEEP IN A SAFE PLACE FOR FUTURE REFERENCE. WHEN WRITING, ALWAYS GIVE THE FULL MODEL NUMBER WHICH IS ON THE NAMEPLATE AT- TACHED TO THE BACK OF THE HEATER.