Table des Matières
Publicité
Liens rapides
THIS MANUAL WILL HELP YOU TO OBTAIN EFFICIENT, DEPENDABLE SERVICE FROM THE HEATER, AND ENABLE YOU
TO ORDER REPAIR PARTS CORRECTLY. KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.
• Please read this entire manual before installation and use of
this appliance. Failure to follow these instructions could result
in property damage, bodily injury, or even death.
• Contact your local building or fire officials about obtaining
permits, restrictions and installation inspection requirements in
your area.
• SAVE THESE INSTRUCTIONS.
• If your heater is not properly installed, a house fire may result.
For everyone's safety, follow all Installation and Operating
Directions. Never use makeshift compromises during the
installation of this appliance. Contact your local building
or fire officials about restrictions and installation inspection
requirements in your area. These Pellet Stove Room Heaters
have been designed for use in the US and Canada and are
suitable for mobile homes.
ALL PICTURES SHOWN ARE FOR ILLUSTRATIVE PURPOSES ONLY.
ACTUAL PRODUCT MAY VARY DUE TO PRODUCT ENHANCEMENT.
This manual is subject to change without notice.
MODEL: AP5660
SAVE THESE INSTRUCTIONS
United States Stove Company
PO Box 151, 227 Industrial Park Rd.,
South Pittsburg, TN 37380
PH: (800) 750-2723
www.usstove.com
Report #: F19-548
Certified to ASTM E1509-12 ( 2017),
and Certified to ULC S627, 2000,
and (UM) 84-HUD
This unit is not intended to be used as a
primary source of heat.
U.S. Environmental Protection Agency
Certified to comply with 2020
Ce produit peut vous exposer à des agents chimiques, y compris au monoxyde de
carbone, lesquels sont reconnus dans l'État de la Californie comme causant le cancer et
particulate emissions standards.
des malformations congénitales ou autres dommages au fœtus. Pour obtenir plus de
renseignements, veuillez consulter le site www.P65warnings.ca.gov
CALIFORNIA PROPOSITION 65 WARNING:
This product can expose you to chemicals including carbon monoxide, which
is known to the State of California to cause cancer, birth defects and/or other
reproductive harm. For more information, go to www.P65warnings.ca.gov
R
852334J-0503J
Publicité
Table des Matières
Manuels Connexes pour Ashley AP5660
Sommaire des Matières pour Ashley AP5660
- Page 1 MODEL: AP5660 SAVE THESE INSTRUCTIONS THIS MANUAL WILL HELP YOU TO OBTAIN EFFICIENT, DEPENDABLE SERVICE FROM THE HEATER, AND ENABLE YOU TO ORDER REPAIR PARTS CORRECTLY. KEEP IN A SAFE PLACE FOR FUTURE REFERENCE. • Please read this entire manual before installation and use of this appliance.
-
Page 2: Important
Safety Precautions • IMPORTANT: Read this entire manual before installing circumstances and a safety concern may arise from and operating this product. Failure to do so may sparks or fumes entering the room. result in property damage, bodily injury, or even •... - Page 3 Watts (igniter running) 346W This manual describes the installation and operation of the Ashley, AP5660 pellet stove. This heater meets the 2020 U.S. Environmental Protection Agency’s crib wood emission limits for woodheaters sold after May 15, 2020. Under specific EPA test conditions burning Douglas Fir dimensional lumber this heater has been shown to deliver heat at a rate of 11,155 to 24,361 Btu/hr.
- Page 4 Installation Attention: DO NOT vent under any porch, deck, awning, or in any semi enclosed or roofed area. Doing so may result in unpredictable airflow at the vent cap under certain conditions and can affect the performance of your stove, as well as, other unforeseeable issues. INSTALLATION OPTIONS Read this entire manual before you install and use your pellet stove.
-
Page 5: Floor Protection
FLOOR PROTECTION This heater must have a non-combustible floor protector (ember protection) installed beneath it if the floor is of combustible material. If a floor pad is used, it should be UL listed or equal. The floor pad or non-combustible surface should be large enough to cover at least the area under the product and 6”... -
Page 6: Pellet Vent Installation
PELLET VENT INSTALLATION The installation must include a clean-out tee to enable collection of fly ash and to permit periodic cleaning of the exhaust system. 90-degree elbows accumulate fly ash and soot thereby reducing exhaust flow and performance of the stove. Each elbow or tee reduces draft potential by 30% to 50%. All joints in the vent system must be fastened by at least 3 screws, and all joints must be sealed with Hi-Temp RTV silicone sealant to be airtight. - Page 7 Installation You have already made the important decision of choosing your U.S. Stove Pellet Burning Room Heater; now your next step is to determine where to install your new pellet stove heater. To get the most efficient use of re- circulated heat, you should consider a room that is centrally located within your home.
- Page 8 Installation THROUGH THE WALL INSTALLATION (RECOMMENDED INSTALLATION) Canadian installations must conform to CAN/CSA-B365. To vent the unit through the wall, connect the pipe adapter to the exhaust motor adapter. If the exhaust adapter is at least 18 in.(457mm) above ground level, a straight section of pellet vent pipe can be used through the wall.
-
Page 9: Mobile Home Installation
Installation OUTSIDE AIR SUPPLY (OPTIONAL, UNLESS INSTALLING IN A MOBILE HOME) Depending on your location and home construction, outside air may be necessary for optimal performance. Metal pipe (solid or flexible) must be used for the outside air EXHAUST PIPE installation. -
Page 10: Appliance Controls
Appliance Controls PANEL/REMOTE CONTROLS The blowers and automatic fuel supply are controlled from a panel on the top of the stove. The control panel functions are a follows. ON/OFF SWITCH (“POWER” BUTTON) • When pushed, the stove will automatically ignite. No other fire starter is necessary. The igniter will stay on for at least 10 and up to 12 minutes, depending on when Proof of Fire is reached. -
Page 11: Proper Fuel
Operation • DO NOT USE CHEMICALS OR FLUIDS TO START THE FIRE - Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or “freshen up” a fire in this stove. Keep all such liquids well away from the stove while it is in use. •... -
Page 12: Opening Door
THE FIRESTARTER 1. Fill hopper and clean burn pot. 2. Press “On/Off” button. Make sure green light comes on. 3. The damper should be completely closed or open no more than ¼ of the way during start-up. This will vary depending on your installation and elevation. -
Page 13: Exhaust System
1. Your stove is equipped with a high temperature thermodisc. This unit has a manual reset thermodisc. This safety switch has two functions. A. To recognize an overheat situation in the stove and shut down the fuel feed or auger system. B. - Page 14 WARNING: FAILURE TO PROPERLY MAINTENANCE THE CLEAN OUTS WILL RESULT IN POOR PERFORMANCE OF THIS STOVE. WARNING: Do not attempt to operate the heat exchange tube cleaner while the pellet stove is in operation or cooling down; wait until pellet stove has cooled completely before performing this procedure. INTERIOR CHAMBERS •...
- Page 15 LOCATING THE FRONT CLEANOUTS (CLEAN ANNUALLY) 1. Remove the front glass by releasing the two latches attaching it to the unit. They are located behind the right side panel. 2. Remove the two side brick panels. 3. Remove the two interior side panels. FRONT CLEANOUTS...
- Page 16 Maintenance FANS – DANGER: RISK OF ELECTRIC SHOCK. DISCONNECT POWER BEFORE SERVICING UNIT Over time ash or dust may accumulate on the blades of the circulation & exhaust fans. The fans should be Auger Motor inspected, periodically, and if any accumulation is present vacuumed clean as the ash or dust can Circulation Fan impede the fans performance.
-
Page 17: Maintenance Schedule
Maintenance FALL START UP Prior to starting the first fire of the heating season, check the outside area around the exhaust and air intake systems for obstructions. Clean and remove any fly ash from the exhaust venting system. Clean any screens on the exhaust system and on the outside air intake pipe. -
Page 18: Disposal Of Ashes
Maintenance DISPOSAL OF ASHES Ashes should be placed in a steel metal container with a tight fitting lid. The closed container of ashes should be placed on a non-combustible floor or on the ground well away from all combustible materials, pending final disposal. -
Page 19: Troubleshooting Guide
Trouble Shooting Guide When your stove acts out of the ordinary, the first reaction is to call for help. This guide may save time and money by enabling you to solve simple problems yourself. Problems encountered are often the result of only five factors: 1) poor fuel;... - Page 20 To test the air switch, you will need to disconnect the air hose from the body of the stove. With the other end still attached to the air switch, very gently suck on the loose end of the hose Air switch has failed. (you may want to remove the hose entirely off the stove and the air switch first and make sure it is clear).
- Page 21 The hopper is out of Pellets. Refill the hopper. When operating the unit, be sure the hopper lid is closed so that the hopper safety switch will activate. Check the wires The hopper safety switch has failed or hopper is open. leading from the hopper safety switch to the control panel and auger motor for secure connections.
- Page 22 Smoke Smell Coming Back Into The Home Possible Causes Possible Remedies: (Unplug stove first when possible) Inspect all vent pipe connections. Make sure they are sealed with RTV silicone that has a temperature rating on 500 degree There is a leak in the vent pipe system. F or higher.
- Page 23 • GLASS “SOOT’S” UP AT A VERY FAST RATE • FLAME IS LAZY, DARK, AND HAS BLACK TIPS • AFTER STOVE HAS BEEN ON FOR A WHILE, THE BURNPOT OVERFILLS Possible Causes Possible Remedies: (Unplug stove first when possible) Stove or vent pipe is dirty, which restricts airflow through Follow all cleaning procedure in the maintenance section of the burnpot.
-
Page 24: Parts List
Parts List... - Page 25 Parts List Part# Description 88161 Glass w/Gasket, Center 88162 Glass w/Gasket, Side 891997 Latch, Ash Pan 891996 Ash Pan 892037 Hearth Trim 891994 Burn Pot 88165 Brick Panel - Right 88163 Brick Panel - Center 88164 Brick Panel - Left 891995 Magnet 891540 Latch, Door 80491...
-
Page 26: Wiring Diagram
Wiring Diagram... -
Page 27: Service Provider
Service Record It is recommended that your heating system is serviced regularly and that the appropriate Service Interval Record is completed. SERVICE PROVIDER Before completing the appropriate Service Record below, please ensure you have carried out the service as described in the manufacturer’s instructions. Always use the manufacturer's specified spare part when replacement is necessary. -
Page 28: How To Order Repair Parts / Comment Commander Des Pièces Détachées
How To Order Repair Parts / Comment Commander Des Pièces Détachées This manual will help you obtain efficient, dependable service from your pellet stove, and enable you to order repair parts correctly. Keep this manual in a safe place for future reference. When writing, always give the full model number which is on the nameplate attached to the heater.