fadini NYOTA 115 evo Mode D'emploi page 24

Nyota 115 evo
ELECTRICAL CONNECTIONS TO THE MAGNETIC LIMIT SWITCH
NOTE WELL: first of all identify the position of Nyota 115 evo in relation to the opening direction of the gate
view from inside (on the left or right). Depending on this, properly connect the brown and green wires of the
limit switch and the wires of the electric motor.
!
NOTE WELL: Nyota 115 evo in the version with incorporated Elpro 12 evo control board comes factory pre-wired
as if it were going to be installed on the left. In case Nyota 115 evo is required to be installed on the right, t
swap the connections to terminals 8 - 10 and 16 - 18.
MOUNT ON THE RIGHT
Magnetic
limit switch
sensor
MOUNT ON THE LEFT
Nyota 115 evo
mounted on the left
Magnetic
limit switch
sensor
electromechanical operator for sliding gates
!
10 1 12 13
8
12/24 Vac/dc
8 12 13
10
!
12/24 Vac/dc
M
17 1
Elpro 12 evo
Elpro 37
Elpro 37 DS
Elpro 37 FN
18 1
16
M
Elpro 12 evo
16 17 1 18 1
Elpro 37
Elpro 37 DS
Elpro 37 FN
20
Nyota 115 evo
installed on the right
Pic. 13
Pic. 14