fadini NYOTA 115 evo Mode D'emploi page 20

Nyota 115 evo
CEMENTING THE ANCHOR BRACKET
Distances in Pic. 3 are to be followed in this step. Once satisfied that concrete has firmly set all around the the bracket,
Nyota 115 evo can be mounted onto it.
MOUNTING NYOTA 115 EVO ONTO THE ANCHOR BRACKET
Cover removing: unscrew the fastening screw completely (Pic. 4), then pull at the bottom in order to remove the cover.
Before fastening Nyota 115 evo by the provided screws, insert the washers under the operator: they will be removed once the
gear rack has been installed. In this way a 2 mm clearance is obtained between the rack teeth and the operator pinion (Pic. 5).
electromechanical operator for sliding gates
Anchor bracket
to be cemented
into a ground
foundation
Cover
fastening
screw
M8 fastening
screw
Washers
to be used as
distance parts
in installing phase
!
70
Inspectable
junction
pit
16
!
80
Pipes for
the electric
cables
M8 nut
Pic. 3
Pic. 4
Pic. 5