Adler europe AD 7742 Mode D'emploi page 7

19. Place the fan heater only on flat, stable surface
20. Always turn the fan heater off and set the thermostat dial to minimum before removin
the power plug from the socket.
21. Never use the fan heater in high humidity rooms – bathroom, shower room, swimming
pools etc. The humidity can cause short circuit, and effect in damaging the device.
22. The operating fan heater needs to be under supervision and in sight all the time. If you
are leaving the room with the fan heater, always turn the fan heater off. If the fan heater is
not used, the power plug has to be removed from the power outlet.
23. Do not connect the fan heater to the automatic switching device, for example
temperature controlling device or time switch.
24. Flammable materials, for example furniture, bedclothes, paper, clothes, curtains should
be kept at least one meter from the fan heater.
25. Do not cover the device or put any objects on it while it is operating. Do not use the
device to dry clothes.
26. The power cord should not be placed above the fan heater, and it should not touch or
be placed near hot surfaces of the fan heater. Do not place the fan heater directly under
the power outlet.
27. The heating surfaces can heat to a temperature of 60 °C or higher. The fan heater
should be in a place that children and animals do not have access to.
28. The device is not intended to be installed or used in vehicles.
29. Some parts inside the device can be hot or cause sparking. Do not use the fan heater in
places, where gasoline, paints or other flammable materials are used or stored.
30. Do not use this heater in the immediate vicinity of a bathtub, shower or swimming pool
31. Do not use this heater if it has been dropped
32. Do not use if there are visible signs of damage to the heater.
33. Use the heater on a level and stable surface or attach it to the wall, if provided for by the
manufacturer
WARNING: Do not use this heater in small rooms where there are people who are
unable to leave them by themselves, unless constant supervision is ensured.
WARNING: To reduce the risk of fire, keep textiles, curtains or other flammable
materials at least 1 m away from the heater air outlet.
DESCRIPTION OF THE DEVICE: CERAMIC FAN HEAER AD7742
1. Thermostat dial
2. Power switch / heating level control
(a) – cold airflow
(b) – 750W
(c) – 1500W
3. Control lamp
USING THE DEVICE
Place the device on flat surface, leave safe area between the device and other objects from the front 120cm and from the other sides of the
device 50cm. Plug in the device.
The heater has two levels of heating power and fan mode.
Position (0) – device is switched off
Position (a) – unheated air flow
Position (b) – 750W warm air flow
Position (c) – 1500W hot air flow
On both heating levels the temperature can be adjusted using thermostat dial (1).
First, turn the power switch (1) into desired position (a, b, c).
Then, turn the thermostat dial (1) to the desired temperature position between MIN and MAX. When you feel the room temperature is
comfortable, turn the thermostat dial (1) anti-clockwise slowly until the device switches off, but not more. The thermostat switch will
keep the room temperature at the desired temperature automatically.
The device is protected against the overheating by the means of a thermal switch, which can power it off for a while. If this happens,
unplug the device and wait 5-10 minutes to let the device cool down. After a while you can continue to use the device.
This device is also equipped with a safety tip-over switch which automatically turns the device off if the it leans or falls. The heater will
resume back to normal when it is returned to the upright position.
7