Publicité
Les langues disponibles
Les langues disponibles
English
Stroke Mode
Trajectory of Motion
Hardness of Material
Cutting Speed
Level of Finish
NOTE
○ To select the stroke mode, operate the change lever when the product is completely stopped.
○ Select Straight Mode if you wish to cut soft materials neatly.
○ Occasionally clean the change lever as its movement may be adversely aff ected if dirt or dust collects on the
change lever.
Change Lever
(Straight Mode)
3. Cutting operation
<Cutting metallic materials>
CAUTION
● Press the base fi rmly against the workpiece.
● Never apply any unreasonable force to the saw
blade when cutting. Doing so can easily break
the blade.
● The motor can be locked sometimes, depending
on the combination of the material to be cut and
the blade. Whenever the motor gets locked,
switch it off immediately.
● Do not operate power tools in explosive
atmospheres, such as in the presence of fl ammable
liquids, gases or dust. Reciprocating saw create
sparks which may ignite the dust or fumes.
(1) Fasten a workpiece fi rmly before operation. (Fig. 19)
16
Straight mode
Back and forth action
Hard material
Slow
Smooth
Fig. 19
Table 6
Back and forth action + up and down action
Fig. 18
(2) When cutting metallic materials, use proper machine
oil (turbine oil, etc.). When not using liquid machine
oil, apply grease over the workpiece.
CAUTION
The service life of the saw blade will be drastically
shortened if you don't use machine oil.
<Cutting lumber>
When cutting lumber, make sure that the workpiece is
fastened fi rmly before beginning. (Fig. 20)
CAUTION
Never apply any unreasonable force to the saw
blade when cutting. Also remember to press the
base against the lumber fi rmly.
Orbital mode
Soft material
Fast
Rough
Change Lever
(Orbital Mode)
Fig. 20
Publicité
