Metabo HPT CR 18DB Instructions De Sécurité Et Mode D'emploi page 10

English
2. Battery Charger
Model
Input power source
Charging time
(At a temperature of 68°F (20°C))
Charging voltage
Charging current
Weight
NOTE: The charging time may vary according to temperature and power source voltage.
APPLICATIONS
○ Cutting metal and stainless steel pipe.
○ Cutting various lumber.
○ Cutting mild steel, aluminum and copper plate.
○ Cutting synthetic resins, such as phenol resin and
vinyl chloride.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
○ How to remove the battery.
Withdraw battery from the tool handle while pressing
the latch (2 pcs) of the battery (Fig. 5).
○ How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 5).
Battery
10
BSL1830C: Approx. 45 min
ASSEMBLY AND OPERATION
Lock-off button
Latch
Pull out
Insert
Push
Fig. 5
UC18YFSL
Single phase: AC 120 V 60 Hz
DC 14.4–18 V
DC 3.5 A
1.1 lbs. (0.5 kg)
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on
the nameplate, the charger will burn out.
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted
into the receptacle, pilot lamp will blink in red. (At
1-second intervals)
UC18YKSL
BSL1820M: Approx. 60 min
0.8 lbs. (0.35 kg)
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.