CLAS PE 2001T Mode D'emploi page 39

PE 2001T
2 COLUMNS ASYMETRIC POST LIFT 400V 4T
7 INSTALLING THE END LIMIT SWITCH
Install the limit switch devices and adjust the angle of the
arms to connect them to the carts.
8 HYDRAULIC INSTALLATION
Place the hydraulic pump on the right side of the column.
Connect the hydraulic connections as shown in Picture 10.
9 INSTALLING THE CONTROL PANEL
Place the control unit on the column and secure it.
Connect the electrical circuit as indicated in the appropriate «electrical diagram» Only competent
personnel are authorized to perform these operations.
Open the front cover of the control unit.
10 INSTALLATION OF THE SAFETY DEVICES
Install the safety switches at the highest end of the control column.
Let the safety switch roller come into contact with the pulley support pin.
Connect the safety switch cables as shown in the circuit diagram (SQ3-SQ4)
Picture 10 Hydraulic
Connections
39