Joycare SICUROFIX Mode D'emploi page 35

5.3 Cleaning
Please be sure to use only original seat covers, as the seat cover is important to the proper functioning of
the system. Replacement seat covers are available from your retailer and or at branches.
The child seat must not be used without the seat cover.
• The seat cover should not be replaced with any other than the one recommended by the manufacturer,
because the cover constitutes an integral part of the restraint performance.
• The cover can be removed and washed with a mild detergent using the washing machine's cycle for
delicate items (30°C). Please observe the instructions on the washing label of the cover. The colours of
the cover may fade if washed at more than 30°C. Do not spin, and never tumble dry in an electric clothes
dryer (the fabric may separate from the padding).
• The plastic parts can be cleaned using soapy water. Do not use harsh cleaning agents (such as
• Also put the end of the harness strap through the harness strap slot and
shell, fix into the strap yoke. Make sure the seat straps can not be rotated.
• Close the buckle, then fasten the cover all around. Close the snap
buttons on the back. Check that it works!
35
• Pass the strap clip through the strap
clip slot. Then, pull both sides of covers
as shown in picture and cover both sides
of holders.
• Pass the end of the shoulder strap
through the harness slot, fix into shoulder
strap axle, and lock the shoulder strap
axle to the seat shell .
GB