Joycare SICUROFIX Mode D'emploi page 32

GB
WARNING
Do not to use any load bearing contact points other than those described in the instructions and marked
in the child restraint.
The belt must be routed as shown in the instructions.
Click
4-4 Installation of Group II/III with car belt and additional connector for
the children whose weight between 15-36kg.
This car seat also allow to install with the ISOFIX, please operate as following:
• Adjust the height of the headrest to suit your child.
• Put the shoulder belt through the shoulder belt guide under the
headrest.
• Place your child into the car seat and pass the belts through the bottom
of the armrest. Fasten the car belt with an audible sound "click".
• Make sure the Lap belt is stretched as low as possible over the child's
hips , within the Belt guides, and fastened into the buckle . the Shoulder
belt must cross midway between child's shoulder and neck.
• Before the installation, please take away the Harness system of baby
car seat.
Note: The Baby inserti, Harness strap, Harness buckle, Buckle pads
& Shoulder pads should be stored away safely for future use (see 5.1
Removing the 5-point harness system and cover).
32