Securing Your Baby Using The Harness - Joycare SICUROFIX Mode D'emploi

3.3 Securing your baby using the harness

3.2-1 Adjusting the belts
• Loosen the harness straps by pressing the release button and pulling
the harness straps as far as you can.
Note! Do not pull the shoulder pads.
3.2-2 Ten heights of the headrest
• The headrest can be set at five different heights in group I mode with
the shoulder belts axle in place. There are five additional positions in
Group II & III mode once the shoulder belts axle and harness straps has
been removed.
• Press the button on the headrest handle on the top of the seat.It is
important to make sure the headrest fit properly to head.
• Loosen the harness straps by pressing the release button and pulling the
harness straps as far as you can.
Note! Do not pull the shoulder pads.
27
3.2-3 Stepless adjustment device
• The recline angles of the car seat can be
adjusted by front knob.
Rotate clockwise to add the recline
angles, to reduce in the opposite, as
shown from the icon on the knob. (Only
For Group I).
• Open the harness buckle, then place the
harness straps to the sides of the car seat.
Put the baby into the car seat.
GB