Joycare SICUROFIX Mode D'emploi page 31

4-2 Group I Car Belt Installation For Children weight between 9-18KG)
• Pull the car belt and insert belt buckle into the cover hole from one side of seat (picture 1), then across
seat back and took out from the other side of cover hole (picture 2) ,finally buckle up until heard "click"
sound (picture 3).
• Please make sure car belt should be through red waist belt guide without no twist.
After installation, tighten car belt as arrow indicator direction (picture4).
• Pull the harness strap as far as you can, and open safety buckle of car seat, then put children inside
5-point harness system and joint buckle clips until heard "click" sound (picture 5).
• Watch your children's feeling, adjust suitable harness tightness by pulling adjusting strap and adjust
headrest to right height.(picture6).
4-3 Installation of Group II/III and it is for the children whose
weight between 15-36kg.
1
4
• Before the installation, please take away the Harness system of baby
car seat.
Note:
The Baby insert, Harness strap, Harness buckle, Buckle pads&
Shoulder pads should be stored away safely for future use ( see 5.1
Removing the 5-point harness system and cover).
31
2
click
5
click
GB
3
6