Fulgor Milano LWD 12 Instructions Pour L'installation Et L'utilisation page 32

WARNING! Before connecting the warming drawer
to the electrical circuit, verify that the voltage and the
frequency correspond to those indicated on the label
located inside the heating block, which should be kept
along with this manual.
The electrical attachment must be made using bipolar
GB
switch capable of powering the appliance and that has
a gap of 3 mm (minimum) to guarantee disconnection
in case of emergency or when cleaning the warming
drawer.
Connect the appliance to the ground circuit to conform to
safety regulations regarding electrical systems.
ATTENTION! THE WARMING DRAWER MUST BE
CONNECTED TO THE GROUND CIRCUIT.
In the event of the failure of the cable supplied with the
warming drawer, replace it with an original replacement
part provided by the Service Department.
The manufacturer and retailers will not be liable for
property damage and personal injury caused by a failure
to follow the instructions provided in this manual.
32