Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8 Decommissioning
The device restarts if settings/values are changed in the following submenus.
Display (13)
Action
7 Press the <◄ ► touch buttons (3)>.
8 Press the <▲▼ touch buttons (3)>.
9 Press the <OK button (4)>.
Tab. 28
Submenu 4 Settings Restart
7.5 In off mode (bypass)
Fig. 1 Functional description on page EN-7
NOTICE
• Gas supply and power supply must remain connected in bypass mode.
Display (13)
Action
1 Press the <power button (ESC) (18)>
Tab. 29
In off mode (bypass)
8 Decommissioning
NOTICE
• When decommissioning the gas management system EWR 2 / EWR 2 Net, ensure that the procedures for switching
off each of the welding system components are observed.
1 Close the gas supply.
2 Switch off the power supply.
EN - 16
for approx. 2 seconds.
Description
The following display appears if invalid Netmask values
exist.
Submenu 6 Netmask is displayed again after three seconds.
Values can be changed here.
The digit/position is selected.
The digits are increased or decreased.
The input is saved and closed. The device restarts.
Description
Device is switched off.
Volume flow and input pressure are displayed.
LED status display (2) illuminates red.
EWR 2 / EWR 2 Net
BAL.0598 • 2018-04-09
Publicité
Chapitres
Table des Matières
