LENCO DAR-081 Mode D'emploi page 13

When the waveband end is reached, your radio will recommence tuning from the opposite waveband
6.
end.
Manual Scan
1. Press the MODE key on the main unit to select "FM Mode''.
Select FM mode as previously described, if required.
2.
Press or shortly adjust tuning. Each press of the tuning button will change the frequency up or
3.
down by 50 kHz.
When the waveband end is reached, the radio will recommence tuning from the opposite waveband
4.
end. If no stations are found, please ensure the aerial is extended and test the reception by doing
another auto scan in a different location.
Menu
1. Scan Setting
In FM mode, press MENU to enter the FM menu, then press
ENTER to select the sensitivity setting:
1.1. All stations: ~15dB
Strong stations only: ~19dB,
1.2.
Audio Setting
2.
Stereo allowed:
2.1.
Forced mono
2.2.
2.3. System (FM system), same as DAB system setting.
3. PRESET:
In FM menu, press [ ] or [  ] station select "Preset Recall", then press [ENTER] to tune to the stored
in preset memory. Or press PROG. Button (15) of the remote control.
or to select [Scan setting], then press
13