LENCO DAR-081 Mode D'emploi page 12

language will have "*" displayed at the top right. Users may choose between English, French, Italian,
Deutsch, Polish, Nederlands, Espanol
Factory Reset
2.
Press [ENTER] to perform a factory reset. If you wish to perform the reset operation, push [
[ ] until "YES" is highlighted on the display and press [ENTER]. A full reset of your radio will be
performed. All presets and station lists will be erased.
SW Version
3.
Press [ENTER] to view DAB software version. Press Menu to stop displaying the software version.
*If there are no operations after 30 seconds, the display will return to normal.
Preset
Preset Recall
1.
In DAB menu, press [
stored in preset memory. Or press PROG. Button (11) of the remote control.
Note: If you have not previously stored a preset station and the preset button is pressed, "Empty
preset" will be displayed.
2. Preset Store
You may store your preferred DAB stations to the preset station memories. There are 50 memory
presets in your radio. Presets are remembered by your radio in the event of a power failure.
In DAB menu, select [Preset store] with
buttons to select a storage space， then press [ENTER] to confirm the desired preset number under
which you will store the station you are currently playing. Press [ENTER] to confirm.
FM Radio
Carefully extend the telescopic aerial to its full length.
Auto Scan
Rotate the MODE knob to select "FM Mode".
1.
Long Press
2.
sufficient signal strength.
After a few seconds, the display will update. The display will show the station frequency. If the signal
3.
is strong enough and the station signal contains RDS data, then the radio will display the station name.
4. To find other stations, press and hold the
To scan the FM band in the opposite direction (high frequencies to low frequencies), press the
5.
button and hold for 2 seconds.
] or [ ] station select "Preset Recall", then press [ENTER] to tune to the
button, and your radio will scan and stop automatically when it finds a station of
and , then press [ENTER]. Press the "previous or next"
button as before.
12
] or