Technical Specifications; Product Description - Ayce LIH-10 Mode D'emploi

insulation layer of wires.
34.
Ensure no water or rain drop into the unit, in order to avoid elec-
tric shock, short circuit or re.
35. Clean the surface of the unit with damp cloth (or add some deter-
gent). Do not use corrosive detergent or solvent to clean. Not
allowed to wash directly with water.
36. Do not handle the power cord and plug by wet hands.
37. Do not insert the wood or metal stick or other slim objects into air
inlet or outlet.
38. Do not put heavy objects onto the power cord.
39.
Do not face the wind outlet to babies for a long time.

TECHNICAL SPECIFICATIONS

Model
LIH-10
Rated Voltage
220-240 V~
Rated Frequency 50 Hz
Max Capacity Power 2000 W
Power Setting
650 W-1300 W-2000 W
Protective Class I
Insulation Class
IP24

PRODUCT DESCRIPTION

1. Handle
2. Control dial
3. Thermostat dial
4. Air outlet
5. Body
OPERATION
Before operation
Note! Since the appliance and its heating coils are slightly greased when delivered, there might be a
slight development of smoke and odour the rst time it is used. This is harmless and stops after a
short a while. Be sure to provide for su cient ventilation during such time.
Warning! Ensure that there is su cient distance from the wall, xtures or other appliances. The
distance must be at least 1 m to exclude the risk of re.
1)Remove all packaging material and keep out of reach of children. After removing packaging, check
the appliance for damage or other signs that could indicate a fault/defect/malfunction. In case of
doubt, do not use the appliance, but contact your vendor for inspection or replacement.
2) Choose a suitable location which is at least one metre away from any obstructions, walls or
in ammable materials (see also safety instructions),
3) Make sure heater is placed on a solid, at and horizontal surface.
4) Check if the control dial is set to 'OFF' (
5) Fully extend the power cord and plug into a suitable 220-240V~ 50Hz socket. To prevent the
circuit overloading, check that no other appliances are connected to the same group.
Operation
Heater
1) Turn the thermostat dial to maximum (clockwise).
2) Switch the heater on by turning the control dial to one of the following three positions:
Heating at low power (650W)
Heating at medium power (1300W)
Heating at high power (2000W)
3) It is most economical to heat the space at high power, then once the desired temperature is
reached, turn the thermostat dial back slowly until you hear a click. The desired temperature is now
set. The heater will automatically switch on and o to maintain the set temperature.
To set a higher or lower temperature, turn the thermostat dial either clockwise or anticlockwise.
Fan
1) Turn the thermostat knob in anticlockwise to the minimum position, then turn the switch to the
position < >for the fan function.
54 | 55
).
GB