Crivit SP-06 Mode D'emploi page 8

LED-rear light SP-06
under the supervision of adults.
• The changing of batteries must only be carried out by adults.
• If the battery leaks, avoid any contact with the skin as this can lead to skin irritation.
• Leaking batteries must be disposed of immediately.
User information
1. Before the first use
Take the tail light off the helmet (Fig. J). Before the first use, remove the safety strips from the
reverse of the LED tail light (Fig. I).
2. Removal and attachment of the tail light
• To remove the rear light, pull the rear light out of the holder (Fig. J).
• To attach it, the LED rear light must be re-plugged on the holder provided for this
purpose.
3. functions
The LED rear light has three different functions, each of which can be used as desired (Fig.
K).
• Press x1: continuous light,
• press x2: flashing light,
• press x3: colour chaser,
• press x4: light off.
4. changing the batteries
The LED tail light comes equipped with a CR 1620 (3V) battery.
• To replace the battery, unlock the screws at the back of the light using a small Phillips
type head screwdriver.
• Subsequently, lift off the lid and the circuit board, exchange the battery and remount
the circuit board and the lid. In doing so, please make sure that the polarity is correct
when installing the new battery (Fig. L).
• Now, attach the lid again using the four screws (Fig. L).
• Battery type:
8