Publicité
Les langues disponibles
Les langues disponibles
CLEANING
IMPORTANT:
Clean the hood and grease filters frequently
according to the following instructions. Replace grease filter before
operating the hood. Reinstall grease filter correctly and replace the
screw in the vent system.
Exterior Surfaces:
IMPORTANT:
Do not use soap-filled scouring pads, abrasive
cleaners, Cooktop Polishing Creme, steel wool, gritty washcloths
or paper towels. To avoid damage to the stainless steel, do not use
cleaners that contain chlorine.
Cleaning Method:
■ Rub in direction of grain to avoid scratching or damaging the
surface.
■ For stainless steel models, use a special stainless steel
cleaner and polish.
■ Liquid detergent or all-purpose cleaner: Rinse with clean water
and dry with soft, lint-free cloth.
Glass cleaner to remove fingerprints.
Metal Grease Filter
For ducted installations:
1. Remove screw from the grease filter retainer.
2. Turn the grease filter retainer to release filter.
3. Wash metal filters as needed in dishwasher or hot detergent
solution.
4. Reinstall the filter by placing the back edge in the channel at
rear of hood. Push filter into place, turn the filter retainer to
secure filter to range hood.
A
5. Replace screw in the grease filter retainer
For non-ducted recirculation installations:
The charcoal filter is not washable. It should last up to 6 months
with normal use.
1. Replace metal grease filter with a charcoal filter.
To replace filter:
1. Remove screw from the grease filter retainer.
2. Turn the grease filter retainer to release filter.
3. Reinstall the filter by placing the back edge in the channel at
rear of hood. Push filter into place, turn the filter retainer to
secure filter to range hood.
4. Replace screw in the grease filter retainer.
RANGE HOOD CARE
A. Filter retainer
12
For non-vented (recirculating) installations:
The charcoal filter is not washable. It should last up to 6 months
with normal use.
1. Replace metal grease filter with a charcoal filter.
To replace filter:
1. Remove screw from the grease filter retainer.
2. Turn the grease filter retainer to release filter.
3. Reinstall the filter by placing the back edge in the channel at
rear of hood. Push filter into place, turn the filter retainer to
secure filter to range hood.
REPLACE THE INCANDESCENT LIGHT BULB
Turn off the range hood and allow the light bulb to cool.
1. Disconnect power.
2. Squeeze the plastic lens cover and remove it from the hood.
3. Screw a new 120v 75W (maximum), A19 light bulb into
socket.
4. Replace lens cover by squeezing cover and inserting tabs
into slots.
A. Light bulb socket (A19)
5. Reconnect power.
B. Lens cover
6. If new light does not operate, make sure the lamp is inserted
correctly before calling service.
B
A
Publicité
