Assembling And Adjustments - Husqvarna AD 10 Manuel D'utilisation

ASSEMBLING AND ADJUSTMENTS

Assembly
WARNING! The machine should be switched
!
off with the power cable disconnected from
the outlet.
CAUTION! Remove the crank from the gear
!
housing when the feed unit is mounted on
the stand. Carelessness can result in
serious personal injury.
• Lock the feed housing lock. See instructions in the
operator' s manual for the stand in question.
• The feed unit can be assembled on both sides of the
stand.
• Assemble the spacer.
• Assemble the quick mounting.
• Pull out the knob for assembling and guide the feed unit
over the quick mounting.
• Release the knob and turn it until the feed unit is in the
correct position. Alternatively, a crank can be connected
on the other side of the gear housing so that the unit can
be run up and down until the correct position is obtained.
• The feed unit can be assembled in any angle.
• Connect the drill motor to the feed unit and the incoming
power cable to the outlet.
– 7
English