Publicité
Les langues disponibles
Les langues disponibles
Assembly & Installation
700 Series Tractors Only
NOTE: References to left, right, front and rear of the tractor are
from the operator's position, unless otherwise stated.
•
Before assembly, place the tractor on a firm, level surface,
disengage the PTO, stop the tractor engine and set the
parking brake.
•
For convenience, pivot the seat forward and leave it in
that position until the grass collector is fully mounted and
assembled.
If you are assembling this bagger unit for use on any model 700
series tractor you will need to install the two tractor mounting
brackets packed in your bagger kit. If you are installing this
bagger unit on any other tractor, disregard these steps and move
to Assemble Mounting Brackets on the next page.
To install these brackets on a model 700 series tractor, follow
these steps:
1.
Install a shoulder bolt from your hardware pack on each
bracket, securing them with flange lock nuts also included
in the hardware pack. Refer to Figure 4-1.
2.
Insert the clevis pins from your hardware pack on each
bracket, securing them with clip pins also included in the
hardware pack. Refer to Figure 4-1.
Figure 4-1
3.
Mount the 700 series tractor mounting brackets to your
tractor using four self-tapping hex screws included with
your kit. See Figure 4-2.
Figure 4-2
4
9
Publicité
