Publicité
Les langues disponibles
Les langues disponibles
10.
Install the ball pin (711-04069) from hardware pack 689-
00091 into the hole in the front of the mower deck as
shown in Figure 4-21, and secure with the included flange
lock nut (712-04064).
Figure 4-21
11.
With the tractor's discharge chute raised up and held open,
install the chute elbow over the chute opening by placing
the top, rear edge of the chute elbow over the rear of the
deck opening, then pivoting the chute elbow down and
over the chute opening. See Figure 4-22.
Figure 4-22
Note: For the chute elbow to be properly installed, the
bottom edge must fall over the bottom of the deck
opening so that the entire deck opening is covered by the
chute elbow. See Figure 4-23.
Figure 4-23
12.
Secure the chute elbow to the tractor's deck by hooking
the chute strap onto the ball pin installed earlier on the
deck. See Figure 4-24.
Figure 4-24
S
ection
4 — A
& i
SSembly
nStAllAtion
15
Publicité
