Publicité
Les langues disponibles
Les langues disponibles
3.
If not already done so by the factory, install the bagger
screen into the bagger cover by first inserting the end
closest to the side with the cutout into the mounting hole,
as in Figure 4-13. Make sure to feed the screen under the
lip, as in Figure 4-14.
Figure 4-13
4.
Clip in the other side by pushing the screen into the
provided cutout. See Figure 4-14.
Make sure screen sits
under the cover's lip
Figure 4-14
5.
Install the bagger cover onto the bag support assembly, as
shown in Figure 4-15. The plastic cover goes inside of the
two mounting tabs.
Figure 4-15
6.
Slide the hinge pin into the hole located on the mounting
tab, as in Figure 4-16. Use the cut-out window (See inset in
Figure 4-16) to line up the hinge pin on the other side and
push pin all the way in until it reaches the end-stop. At this
point the pin clips into place and is secured by a tab in the
bagger cover. See Figure 4-17.
Figure 4-16
S
ection
4 — A
& i
SSembly
nStAllAtion
13
Publicité
