MTD 19A30004000 Manuel De L'opérateur page 14

7. Open Hood by pushing in on the rear, right-side tab with
your right hand, as shown in 1 of Figure 4-18, and lifting the
cover with your left hand in the center rear of the bagger
cover, 2.
2
14 S 4 — A
ection SSembly
Figure 4-17
1
Figure 4-18
& i
nStAllAtion
8. Install both bag assemblies onto the bag support brackets
by inserting the front edge in first, as shown in Figure
4-19, and setting the back edge down until it fits into the
assembly.
1
Figure 4-19
9. Install the rubber chute strap (723-04008A) onto the chute
elbow using clevis pin (711-05063), washer (736-0204) and
Bow-tie cotter pin (714-04040) from hardware pack 689-
00091. See Figure 4-20.
Figure 4-20
2