MTD 19A30004000 Manuel De L'opérateur page 12

Note: If you decided to leave the hitch support only
finger tight during the assembly process, tighten all of the
hardware securely at this time.
1. Install the vertical support bracket onto the mounting
assembly of the tractor by hooking it over the hitch plate in
the center, lining up the center mounting hole as shown in
Figure 4-9.
2. Align the vertical support bracket with the mounting hole
that best suits the deck size of your machine.
Note: Hole "B" suggested for 42" decks, and Hole "C"
suggested for 46" decks. Some kits may contain plates with
deck size suggestions instead of letters.
3. Secure the vertical support bracket to the mounting
assembly using a carriage bolt (710-0276) and wing knob
(720-04122) from hardware pack 689-00328A. See Figure
4-10.
12 S 4 — A
ection SSembly
Figure 4-9
Figure 4-10
& i
nStAllAtion
4. Install the hanger assembly onto the upright support
bracket using a carriage bolt (710-0276) and wing knob
(720-04122) from hardware pack 689-00328A. See Figure
4-11.
Figure 4-11
Assembling Remaining Bagger Components
Now that the mounting brackets are assembled and are in place
on the tractor, follow these steps to assemble the remaining
bagger components.
1. Snap the plastic upper chute support in place by first
clipping the side portion onto the bagger support rail (1)
with the edge of the snap feature aligned with the red line,
as shown in the inset of Figure 4-12.
2. Snap the front side of the chute support to the rail (2), as
shown in Figure 4-12.
2
Figure 4-12
1