Garland GRASS 1065 ZSH Manuel D'instructions page 45

Do not tilt the machine with the engine running except
in the special case that you have to start cutting an
area with tall grass. This is the only case in which you
can raise the front wheels slightly to facilitate entry of
the mower to the work area. Stop the lawnmower's
engine if you tilt it to cross surfaces other than grass
and when transporting the lawnmower to and from the
area to be cut.
Do not go near the machine's cutting tool when it is
running.
Danger! Risk of finger amputation.
DANGER
DO NOT USE MOWER WITHOUT ENTIRE Keep hands and feet away from the
GRASS CATCHER OR DEFLECTOR IN PLACE
KEEP HANDS and FEET AWAY
blades.
Do not solely rely on the security features of this
machine.
It is necessary to pay attention to the possible
loosening or overheating of the parts of the machine.
If you detect any anomaly immediately stop the
machine and check it carefully.
In case of mechanical failure take the machine to the
technical service for repair. You should not continue
working if you notice that the operation is not correct.
Remember to always use the machine with clean
hands and without any fuel or oil remains.
Clean the work area and remove all obstacles that
may cause accidents. Check the work area when
going to work and remove all items that could become
entangled in the cutting tool. Also remove all the
objects that the cutting tool can violently eject while in
operation.
Do not allow anyone to enter the work perimeter. This
work perimeter must be 15 meters and is a danger
zone.
You must turn off the engine when you are moving
between work areas.
Never leave this machine unattended.
Be careful not to touch the hot parts of the
machine while the engine is running or after
use, such as exhaust, spark plug or high voltage cables.
Do not use other accessories this machine except
those recommended by our company since its use
could cause severe damage to the user, people close
to the machine and the machine itself.
Always follow the safety rules given in this manual.
7.1. HOLDING AND GUIDING THE MACHINE
Stand behind the mower and direct it while walking
behind it.
This lawnmower is self-propelled. Do not push the
mower; allow it to continue at its speed and limit
yourself to directing the machine in the work area.
7.2. ADJUSTING THE CUTTING HEIGHT
WARNING! Stop the machine and wait until the
blade stops before proceeding to adjust the height.
Blades need a few moments to stop completely after
you turn off the engine.
To regulate the cutting height
adjustment, press the mower level
away from the lawnmower and
move it forward or backward to the
desired height.
45/172
While working, always hold the
lawnmower with both hands on the
handlebar.
English