Garland GRASS 1065 ZSH Manuel D'instructions page 44

English
6.5. TRACTION DRIVE
Press the traction handle against the handlebar, as
shown in the figure, and the mower traction will start
operating.
This model has 4 different traction speed options.
6.6. CHECKPOINTS AFTER STARTING THE MACHINE
It is important to pay attention to the possible
individual parts or and the temperature of the
machine. If you detect any anomaly in the machine
immediately stop and check it carefully.
In case of any malfunction or problem take the
machine to a service technician to be repaired.
Under no circumstances must you continue to use the
machine if the operation does not seem appropriate.
Do not use the machine if it is damaged or improperly
adjusted.
7. USING THE MACHINE
Use this machine only for the designated
purposes. Using this chainsaw for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
Do not start the machine in a room or enclosure.
gases produced by poor ventilation, remove all that
impedes the flow of clean air to improve ventilation
from the work area and not return to work in the area
4 Speeds
unless you have properly ventilated area and have
MIN
clear that ventilation is sufficient so that does not
happen this concentration again.
Work only in daylight or good artificial light. Do not use
this machine at night, with fog or with a low visibility
MAX
which do not allow you to clearly see the working
area.
Whenever possible, avoid using this machine when
the ground is wet. Pay special attention if you use this
machine when it is raining or after it has rained, as
the ground will be slippery and you could slip and fall.
Do not use this machine on slopes greater than 15°.
Cutting on hilly areas can be dangerous.
Be alert when you walk on slopes or wet grass. Slopes
always cut horizontally, not cut bottom up or top down.
Be especially careful when changing direction on a
slope.
Never cut with the mower in reverse or by pulling it.
Be alert when you back up or pull the mower towards
you.
44/172
The exhaust gases and fuel and oil vapors
contain carbon monoxide and harmful
chemicals. In case of a concentration of