ECOVACS ROBOTICS DEEBOT OZMO 937 Mode D'emploi page 8

1. Important Safety Instructions
RF exposure warning
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This equipment must be installed and operated in accordance with provided instructions
and the antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be collocated or operating in
conjunction with any other antenna or transmitter.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its
gain should be so chosen that the equivalent is otropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication.
User manuals for transmitters equipped with detachable antennas shall also contain the
following notice in a conspicuous location:
This radio transmitter (identify the device by certification number, or model number if
Category II) has been approved by Industry Canada to operate with the antenna types
listed below with the maximum permissible gain and required antenna impedance
for each antenna type indicated. Antenna types not included in this list, having a gain
greater than the maximum gain indicated for that type, are strictly prohibited for use with
this device.
IMPORTANT NOTE:
Radiation Exposure Statement:
This equipment complies with "Industry Canada RSS-102 for radiation exposure limits
set forth for an uncontrolled environment".
This equipment should be installed and operated with minimum distance 20cm between
the radiator and your body.
To disable Wi-Fi module on DEEBOT, power the robot ON. Place the robot on the
Docking Station making sure the Charging Contacts on DEEBOT and the Docking
Station Pins make a connection.
Press and hold the AUTO Mode Button on the robot for 20 seconds until DEEBOT emits
3 beeps.
To enable Wi-Fi module on DEEBOT, power the robot OFF and then power ON. The Wi-
Fi module is turned on when DEEBOT is restarted.
6
EN