Publicité
5
5 Preconfiguring the Heat Pump Heating System
The preconfiguration informs the controller about which
components are connected to the heat pump heating system.
Preconfiguration must be carried out before the system-specific
settings in order to show or hide menu items (dynamic menus).
The following table shows not only the menu structure and
explanations
in
the
right-hand
5.1 Menu
You can access the preconfiguration menu by:
Simultaneously pressing (approx. 5 seconds) the button
combination (ESC) and (MENU).
Exit the preconfiguration via the (ESC) button.
The following presettings must be carried out:
E-6
column,
but
also
the
Preconfiguration of all system components for
dynamic menu structuring
Has the system got a heating circuit 2 with a
controllable mixer?
Is active cooling implemented in the system?
Is DHW heating carried out by the heat pump?
Is a sensor or thermostat used to regulate DHW
heating?
Is a flange heater used in the hot water cylinder
for thermal disinfection?
corresponding setting ranges. Values in bold print indicate the
factory settings.
The factory settings in the "Preconfiguration" menu correspond
to the integration diagram for a mono energy heat pump
(normally an air-to-water heat pump) with 1 compressor and a
heating circuit, without DHW heating using the heat pump.
Abbreviations:
HP
Heat pump
AW HP
Air-to-water heat pump
BW HP
Brine-to-water heat pump
WW HP
Water-to-water heat pump
Setting range
No
Yes
No
Yes
No
Yes
Sensor
Thermostat
No
Yes
Display
Always
Always
Always
Domestic hot water
preparation
Domestic hot water
preparation sensor
Publicité
Chapitres
