Publicité
Les langues disponibles
Les langues disponibles
Injector
adjustment
Injector output is controlled by position of
indicator cap. Indicator cap limits travel of
indicator piston.
To achieve advertised minimum output
setting (0.001 in
3
, 0.016 cm
3
) hand tighten
indicator cap against stop then loosen
approximately
/
turn.
1
2
Retracting indicator cap two full turns
from hand tight position permits maximum
output of 0.003 in
3
(0.049 cm3) to be
dispensed. Use graduations on cap as an aid
in setting indicator.
When injector has been adjusted for
proper lubricant output, lock nut is tightened
against face of indicator cap.
NOTE
Any output setting below
should be monitored to verify actual
output volume.
1
2
/
turn
Indicator cap must not extend beyond
1
2
retracted postion of indicator stem.
light personal injury or damage
to equipment.
Fig. IPB 1
3
9
CAUTION
Failure to comply may result in
Publicité
