Husqvarna 372XP X-Torq Manuel D'utilisation page 2

Symbols on the machine:
WARNING! Chainsaws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you understand
the instructions before using the
machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator ' s hands must be
used to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Contact of the guide bar tip with any
object must be avoided.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May cause
serious personal injury.
Recommended cutting
equipment in this example: -
Bar length 18 inches - Max
tooth count for the bar nose
sprocket is 11T - Chain type
Husqvarna H42
Measured maximum kickback value with
brake for the bar and chain combination
on the label.
Measured maximum kickback value
without triggering the brake, for the bar
and chain combination on the label.
Chain brake, activated (right) Chain
brake, not activated (left)
2 – English
KEY TO SYMBOLS
Decompression valve: Press the valve
to reduce the pressure in the cylinder and
make starting easier. You should always
use the decompression valve when
starting the machine.
Ignition; choke: Set the choke control
in the choke position. This should
automatically set the stop switch to the
start position.
Adjustment of the oil pump
If your machine bears this symbol it is
equipped with heated handles.
The rating plate
showing serial number.
yyyy is the production
year, ww is the
productionweek.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
yyyywwxxxxx