Troubleshooting; Installation Instructions - ZANKER KAV6046XXK Notice D'utilisation

To remove the dirt:
1. – Remove immediately: melted plastic, plastic
foil, and food with sugar. If not, the dirt can
cause damage to the appliance. Use a special
scraper for the glass . Put the scraper on the
glass surface at an acute angle and move the
blade on the surface .
– Remove after the appliance is sufficiently
cool: limescale rings , water rings, fat stains,

Troubleshooting

Problem
You cannot activate the appliance
or operate it.
The residual heat indicator does not
come on.
You cannot activate the outer ring.
If you tried the above solutions and cannot repair the
problem, speak to your dealer or the customer service.
Give the data from the rating plate, three digit letter
code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.

Installation instructions

Warning! Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, record the infor-
mation below from the rating plate. The rating plate is
on the bottom of the appliance casing.
• Model ...........................
2.
3.
Possible cause
Problem with the house electrical
system.
The cooking zone is not hot be-
cause it operated only for a short
time.
Make sure, you operated the appliance correctly. If not
the servicing by a customer service technician or dealer
will not be free of charge, also during the warranty peri-
od. The instructions about the customer service and
conditions of guarantee are in the guarantee booklet.
• PNC .............................
• Serial number ....................
Built-in appliances
• Only use the built-in appliances after you assemble
shiny metallic discolorations. Use a special
cleaning agent for glass ceramic or stainless
steel.
Clean the appliance with a moist cloth and some
detergent.
At the end rub the appliance dry with a clean
cloth.
Activate the appliance again and
set the heat setting in less than 10
seconds.
Examine the fuse in the electrical
system of the house in the fuse
box. If the fuses blow again and
again, speak to qualified electrician.
If the cooking zone should be hot,
speak to the service centre.
Activate the inner ring first.
the appliance into correct built-in units and work sur-
faces that align to the standards.
Remedy
13