ASSEMBLY
WARNING:
If any parts are damaged or missing, do not
operate this tool until the parts are replaced. Use
of this product with damaged or missing parts
could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create
accessories not recommended for use with this
tool. Any such alteration or modification is misuse
and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly
is complete. Failure to comply could result in
accidental starting and possible serious personal
injury.
WARNING:
Do not lift the saw without help. Hold it close
to your body. Keep your knees bent and lift
with your legs, not your back. Ignoring these
precautions can result in back injury.
WARNING:
Never stand directly in line with the blade or allow
hands to come closer than 3 in. to the blade. Do
not reach over or across the blade. Failure to
heed this warning can result in serious personal
injury.
WARNING:
To avoid serious personal injury, always make
sure the table saw is securely mounted to a
workbench or an approved leg stand. NEVER
operate the saw on the floor.
ASSEMBLING THE LEG STAND
See Figures 7 - 12.
Many of the leg stand parts are movable. All hardware must
be tightened securely but not so tight that the leg stand won't
open and close. For easier assembly, match letter to letter
and fingertighten all fasteners. Only tighten fasteners securely
when you are sure the release lever locks over the stop pin.
Align handle with holes in the end of the upper tube and
insert. Secure in place using a screw and lock nut. Repeat
for other side.
LETTERS
SCREW
15 − English
LOCK
NUT
Fig. 7
UPPER
TUBE
HANDLE
Fig. 8