RIDGID R4513T Manuel D'utilisation page 14

LOOSE PARTS LIST
SCREW
ASSEMBLY
UNPACKING
This product requires assembly.
 Carefully lift the saw from the carton and place it on a
level work surface.
NOTE: This tool is heavy. To avoid back injury, keep your
knees bent and lift with your legs, not your back, and get
help when needed.
WARNING:
Do not use this product if any parts on the
Loose Parts List are already assembled to
your product when you unpack it. Parts on this
list are not assembled to the product by the
manufacturer and require customer installation.
Use of a product that may have been improperly
assembled could result in serious personal injury.
UPPER
TUBE
LOCK
NUT
CARRIAGE
BOLT
14 − English
CENTER
BRACE
HANDLE
LOCK
NUT
LARGE
SPACER
SMALL
SPACER
INNER LEG
ASSEMBLY
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have carefully
inspected and satisfactorily operated the tool.
NOTE: Remove the foam block from between the saw's
housing and the motor.
 The saw is factory set for accurate cutting. After assembling
it, check for accuracy. If shipping has influenced the
settings, refer to specific procedures explained in this
manual.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
FLAT WASHER,
SMALL
LOCK
NUT
WHEEL
FLAT WASHER,
LARGE
Fig. 6