Publicité
Les langues disponibles
Les langues disponibles
Payment system
kit (BSK)
Peak-load negoti-
ation kit (BSS)
Connections 3 to 12 are for liquid detergent. These connectors are
sealed and must be cut to the diameter of the hose with a small saw.
If opened connectors are no longer required, they must be resealed
using a suitable sealant (e.g., silicone).
Connection terminals for five time-controlled dispenser pumps, which
can be operated without a multifunction module, are located behind
the cover adjacent to the electrical connection.
Calibration of the dispenser pumps and regulation of dispensing
quantities is carried out semi-automatically for washing machines
fitted with an optional multifunction module. Information regarding
settings is given in the operating instructions.
A flowmeter or flow sensors can be connected for precise monitoring
of the dispensing quantity.
Connections for level monitoring are available for every agent dis-
pensed.
Optional accessories
Only use genuine Miele spare parts and accessories with this ma-
chine.
Using parts or accessories from other manufacturers will void the
warranty, and Miele cannot accept liability.
The washing machine can be equipped with a payment system (e.g.,
for self-service operations) using the optional BSK payment system
kit. This must be connected and programmed by Miele Technical Ser-
vice. Payment systems with mechanical or electronic coin validator
are available from Miele as optional accessories for individual target
groups.
The programming required for connecting a payment system must
be carried out by Miele Technical Service or an authorized
Miele dealer only. An external power supply is not required for a pay-
ment system.
The washing machine can be connected to an energy management
system via a peak-load negotiation kit which is available as an op-
tional accessory.
Peak-load negotiation monitors the energy consumption of a system
and deactivates individual pieces of equipment temporarily in order
to ensure that certain total load limits are not exceeded. Monitoring
is externally controlled.
The kit provides three signal contacts and a neutral conductor via a
terminal block. The terminal block is marked with "a", "b", "c", and
"d":
en - Installation notes
9
Publicité
