Intensive Drying
The final rinse uses a higher temperature which improves the drying
results. The running time may increase slightly.
To turn intensive drying on:
Press the [On/Off] button.
1
Hold down the "A" button and press [Start] until the display indi-
2
cates "d:00". Release both buttons
3
Press the "A" button until the display shows "d:00".
4
Press the "C" button to turn intensive drying on or off. "d:01" = ON
and "d:00" = OFF and press [Start] to save setting.
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash
cycle ends. This setting can be adjusted from P:00 to P:02.
To change the setting:
Press the [On/Off] button.
1
Hold down the "A" button and press [Start] until the display indi-
2
cates "d:0x" (x can be any number). Release both buttons.
Press the "A" button until the display indicates "P:0x".
3
Press the "C" button until the display corresponds with your requirements.
4
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
Press [Start] to save the setting
5
InfoLight® (model dependent)
An LED illuminates the floor to indicate the unit is running. If the appliance is
installed at eye-level, the LED is not visible.
To change the setting:
Open the door and press the [On/Off] button.
1
Hold down the "A" button and press [Start] until the display indicates
2
"d:00".
3
Release both buttons.
4
Press the "A" button until the display shows "1:01".
5
Press the "C" button to switch between "1:01" = ON and "1:00" = OFF
and press [Start] to save.
Child Lock (model dependent)
1
Start the desired cycle.
2
Hold down the button that says "Child Lock" underneath it for approxi-
mately 3 seconds until the display reads "CL".
3
The "CL" will be indicated now if any button is pressed and the pro-gram
will not be reset.
To deactivate the child lock, hold down the "Child Lock" button for approxi-
mately 3 seconds until the display no longer reads "CL".
19
.