Gastro M 60/30 FT G Serie Installation-Emploi-Entretien page 27

REPLACING THE BURNER, THE PILOT BURNER, THE
THERMOCOUPLE, THE PIEZOELECTRIC IGNITION
AND THE IGNITER
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
ELECTRIC FRY-TOP
REPLACING THE HEATING AND LIGHT GLOWS.
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE WORKING THERMOSTAT AND
SAFETY THERMOSTAT
- Remove the control panel.
- Remove the bulb from its seat on the bottom of the
hotplate.
- Remove and replace the component.
- Insert the bulb properly in its seat on the bottom of
the hotplate.
- Reassemble all parts. For assembly, proceed in
reverse order.
21. CLEANING THE INTERIOR
Check the condition of the inside of the appliance.
Remove any built-up dirt.
Check and clean the fumes exhaust system.
22. MAIN COMPONENTS
GAS FRY-TOP WITH TAP
- GAS COCK
- MAIN BURNER
- Pilot burner
- Thermocouple
- Igniter
- Piezoelectric ignition
GAS GRIDDLE WITH THERMOSTATIC TAP
- Thermostatic tap
- MAIN BURNER
- Pilot burner
- Thermocouple
- Piezoelectric ignition
- Igniter
ELECTRIC FRY-TOP
- Working thermostat
- Safety thermostat
- Heating element
- Indicator light
27