Gastro M 60/30 FT G Serie Installation-Emploi-Entretien page 25

- Do not use chemical products containing chlorine.
- Do not use sharp objects which might scratch and
damage the surfaces.
CHROMED HOTPLATE
- Clean the cooking surface while it is still moderately
hot (approx. 80-100 °C). Use a cloth or sponge
soaked in water and vinegar. Rinse repeatedly and
dry thoroughly.
- Do not use pan scourers or abrasive powder
detergents.
- Do not use chemical products containing chlorine.
- Do not use sharp objects which might scratch and
damage the surfaces.
COLLECTION TRAYS
- Clean the surface, removing grease, oil, food
residue etc.. .
V. INSTRUCTIONS FOR MAINTENANCE
16. REMINDERS FOR THE
MAINTENANCE TECHNICIAN
THE MANUFACTURER WILL NOT BE
LIABLE FOR ANY DAMAGE OR INJURY
RESULTING FROM FAILURE TO
OBSERVING THE FOLLOWING RULES.
Identify the specific appliance model. The model
number is detailed on the packing and on the
appliance dataplate.
The appliance must be installed in a well-ventilated
room.
Do not obstruct any air vents or drains present on
the appliance.
Do not tamper with appliance components.
Appliance maintenance and conversion to a
different type of gas must be carried out by
qualified technicians
manufacturer, in compliance with current safety
standards and the instructions in this manual.
17. CONVERSION TO ANOTHER TYPE
OF GAS
See Chapter " Instructions for installation ".
authorized by the
18. COMMISSIONING
See Chapter " Instructions for installation ".
19. TROUBLESHOOTING
GAS FRY-TOP WITH TAP
THE PILOT BURNER DOES NOT LIGHT.
Possible causes:
- Insufficient gas supply pressure.
- Blocked tubing or nozzle.
- Defective gas tap or valve.
- Igniter defective or not properly connected.
- Igniter or igniter wire defective.
PILOT BURNER GOES OUT DURING USE.
Possible causes:
- Insufficient gas supply pressure.
- Defective gas tap or valve.
- Defective thermocouple or insufficient heating.
- Thermocouple incorrectly connected to gas tap or
valve.
-
Knob of gas tap or valve not pressedsufficiently.
THE MAIN BURNER DOES NOT LIGHT (EVEN
THOUGH PILOT IS LIT).
Possible causes:
- Insufficient gas supply pressure.
- Blocked tubing or nozzle.
- Defective gas tap or valve.
- Defective burner (gas outlet holes clogged).
HEATING CANNOT BE ADJUSTED.
Possible causes:
- Defective gas valve.
GAS GRIDDLE WITH THERMOSTATIC TAP
THE PILOT BURNER DOES NOT LIGHT.
Possible causes:
- Insufficient gas supply pressure.
- Blocked tubing or nozzle.
25