Sherco SE 250i Manuel Du Propriétaire page 78

n sequence of functions
TOTal Td
To change the unit
of measurement
n instantaneous speed function
Fig1 Instantaneous speed function
n odometer function - Total
Fig 2 Odometer function - TOTAL
n TD Function - daily km traveled
Fig3 Function TD
a short press of the button changes functions
ave laP Max CTdWn HPerC
Displays the current speed of the vehicle. The
speed can be displayed in km / h (default) or
mph. ( p.79)
☛
Displays the total mileage traveled by the vehicle.
The total distance is displayed in the selected
unit, km / h (default) or mph. (
This information can not be reset to 0.
Beyond 99, 999 km (or miles), the counter
goes back to 0.
Displays the mileage traveled by the vehicle
between resets. The distance is displayed in the
chosen units, km / h (default) or mph. (
This information can be reset to 0 by holding down
the button (function TD) for about 2 seconds until
the value 000.0 appears.
Reset to 0 → TD Function → Hold the Button
down for 2 seconds → 000.0 → Reset to 0 done.
Beyond the 999 km (or miles), the counter resets
to 0.
rPM sTdby
To change
the hour
p.79)
☛
p.79)
☛
77