Sherco SE 250i Manuel Du Propriétaire page 118

reinsTalling THe HeadligHT HOUsing
3
rePlaCing THe HeadligHT bUlb Or THe PilOT laMP
1
2
1
3
2
Connect the electrical connector.
Engage the light plate, ensuring that the holes in
the plate are in place
1
Place all of the brake hoses / cables in the inte-
rior of meter upper guide
Attach the rubber fastners.
Check the setting of headlight beam. (
Remove the headlight housing assembly
( p.116)
☛
Remove the protective rubber
Turn the socket a quarter turn counterclockwise
to remove it from the headlight assembly.
Gently press the bulb in while turning it counter-
clockwise and remove it from the socket.
Install a new bulb
2
Headlight bulb S2
Reinstall the socket with the bulb in the headlight
assembly by turning it in a clockwise direction.
Reinstall the protective rubber.
To replace the pilot light
socket from the reflector
Pilot light W5W
Reinstall the headlight housing assembly
( p.117)
☛
.
2
.
3
☛
1
.
12V 35/35W S2
simply remove the
3
.
2
12V 5W
p.118)
117