Publicité
EX-LRT
OP1
54
English
8. Operation (EX-LRT only)
WARNING
This product is equipped with extremely sharp
blades, and when used improperly these blades
can be extremely dangerous, and improper
handling can cause accidents which may in turn
lead to serious injury or death. For this reason,
you should always be careful to follow the
following instructions when using your trimmer.
• Never hold the trimmer in a way in which the
blades are pointed towards someone else.
• Never allow the blades to come into proximity with
your body while the engine of the trimmer is in
operation.
• Always be sure to turn off the engine before
changing the angle of the blades, removing
branches which have become stuck in the blades,
or at any other time when coming into close
proximity with the blades.
• Always wear work gloves made of leather or some
other sturdy material when using the trimmer.
• Always place the blade cover provided with the
trimmer over the blades when not in use.
• Falling branches may fall onto the face or into
the eyes, resulting in injuries, scratches, and
cuts, and for this reason you should always be
sure to wear a helmet and face protector when
using your trimmer.
IMPORTANT
The thickness of branches which may be cut using
this trimmer is limited to up to approximately 3/16"
(5mm). Never try to cut branches thicker than this,
as doing so may result in damage to the trimmer.
■ ADJUSTING THE ANGLE OF THE CUTTING
BLADES (OP1)
1. Stop the engine.
2. Turn the bolt located on the top of the trimming
mechanism counter-clockwise to loosen it.
3. Adjust the angle of the blades to the desired angle,
and then fix the bolt firmly back into place.
(1) Clamp lever
(2) Trimming mechanism
(3) Tighten
(4) Loosen
Publicité
