CASO DESIGN VC100 Manuel D'instructions page 44

The first weld on the cut
off piece of the roll is not
being carried out.
A complete vacuum is
not being created in the
bag.
The bag is not being
welded correctly
The bag does not hold
the vacuum after it has
been welded shut
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
19 Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials. However,
they also contain damaging substances, which were necessary for their
functionality and safety.
If these were put in the non-recyclable waste or were handled incorrectly, they
could be detrimental to human health and the environment. Therefore, do not put
your old device into the non-recyclable waste under any circumstances.
Utilise the collection point, established in your town, to return and recycle old electric
►
and electronic devices. If necessary, contact your town hall, local refuse collection
service or your dealer for information.
Ensure that your old device is stored safely away from children until it is taken away.
►
20 Guarantee
We provide a 24 month guarantee for this product, commencing from the date of sale, for
faults which are attributable to production or material faults. Your legal guarantee
entitlements in accordance with § 439 ff. BGB-E remain unaffected by this.
Roll is not positioned
correctly
The open end of the bag is
not completely inside the
vacuum chamber
The bag is defective
There is dirt on the welding
and the normal seals
The welding bar is
overheating so that the bag
melts
The bag is defective
There are leaks along the
welding seam as a result of
creases, crumbs, grease or
liquids.
Please note
Please note
Follow the steps in the chapter
"Vacuum packaging in a bag
originating on the roll"
Position the bag correctly
Select another bag
Clean the seals and retry
correctly once they are dry
Open the cover on the unit and
let it cool down for a few minutes
Select another bag; wrap paper
serviettes around any sharp
edges on the content
Open the bag again and clean
the upper internal part of the bag
and remove any foreign matter
that might be on the welding bar
before you weld the bag shut
again.
44