Vitrifrigo Slim Serie Manuel D'instructions page 25

SLIM 250
•
G
H
I
J
K
L
M
5. INSTALLATION
Place the fridge on a flat and stable surface.
The fridge is equipped with 4 fixing points (Slim 90 e 150) or 6 fixing points (Slim 250). Before
installation it is necessary to drill the insulated casing in the points indicated in (Annex
2) We recommend using 3.9x16 screws (not supplied). To access all the fixing points it is
necessary to remove the drawer (slim 150).
For the Slim 90 and 150 the motor/condensing unit can be positioned up to about 1.5
m from the refrigerator unit. Position the unit in such a way as to guarantee adequate
ventilation and away from heat sources (Annex 3).
Position the condensate drain hose to drain water out of the vehicle (only Slim 90 and
Slim 150)
ATTENTION Keep the ventilation openings in the compartment where the
compressor unit is housed free from obstructions.
6. DOOR INVERSION
You can reverse the door opening direction by following the steps below.
Door removal
Unscrew the control panel and move it to make the hinge free to move. Then unscrew
the hinge. Finally remove the door (Annex 4).
A
A) Control Panel
B
B) Fridge door
C) Fridge door latch
D) Inside drawers
E) Door shelf
C
F) Drawer latch
G) Fridge compartment
D
H) Insulated box
I) Wire shelves
E
J) Bottle retainer
F
K) Fridge drawer
L) Indoor condensing unit
M) Airself vent
ENG
25