Publicité
Les langues disponibles
Les langues disponibles
Bit grease (optional accessory)
2
1
015228
Coat the bit shank head beforehand with a small
amount of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.).
This chuck lubrication assures smooth action and longer
service life.
Installing or removing the bit
1
015229
1
015230
Pull the change ring down all the way and insert the bit
into the tool holder as far as it will go. Release the
change ring and it will return automatically to its original
position to secure the bit. After installing, always make
sure that the bit is securely held in place by trying to pull
it out. To remove the bit, pull the change ring down all
the way and pull the bit out.
OPERATION
CAUTION:
Make sure the work material is secured and not
•
unstable. Flown object may cause personal injury.
Do not pull the tool out forcibly even the bit gets
•
stuck. Loss of control may cause injury.
Always use the side grip (auxiliary handle) and
•
firmly hold the tool by both side grip and switch
handle during operations.
1. Bit shank
2. Grease
1. Bit
2. Change ring
2
1. Bit
2. Change ring
2
015286
Chipping/Scaling/Demolition
Hold the tool firmly with both hands. Turn the tool on
and apply slight pressure on the tool so that the tool will
not bounce around, uncontrolled. Pressing very hard on
the tool will not increase the efficiency.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
1
001146
When the resin insulating tip inside the carbon brush is
exposed to contact the commutator, it will automatically
shut off the motor. When this occurs, both carbon
brushes should be replaced. Keep the carbon brushes
clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only
identical carbon brushes.
015231
Use a screwdriver to remove the rear cover.
5
1. Commutator
2. Insulating tip
2
3. Carbon brush
3
1. Screwdriver
2. Rear cover
1
2
Publicité
