en-us
Operating the appliance
Individual parts of the wok burner
Ensure that the individual parts of the wok burner are
fitted in the correct position and are straight; otherwise,
this may result in ignition problems or problems during
operation. Fit the burner head such that the
thermocouple is positioned in the corresponding recess
on the burner head. The lug on the burner ring must
engage in the corresponding recess on the burner head.
Note: If the burner parts are fitted at an angle, the
appliance will not work.
(
Burner cap
0
Burner ring
8
Burner head
@
Thermocouple
H
Ignition plug
14
Operating the appliance
O p e r a t i n g t h e a p p l i a n c e
N otes
Only use the accessories specified. Do not line the
▯
stainless steel recess (e.g. with aluminum foil).
The burner and ignition plug must be clean and dry.
▯
Only light the burners if the pan supports and all
▯
burner parts are correctly fitted.
Do not touch the ignition plug while the gas appliance
▯
is being lit.
It is important to keep the appliance clean. If the
▯
ignition plugs are dirty, this may cause ignition
problems. Clean the ignition plugs regularly with a
small, non-metallic brush. Take care to prevent the
ignition plugs from suffering any heavy knocks.
When you cook using a wok, place the wok ring onto
▯
the pan support over the wok burner. Make sure that
the wok is stable on the wok ring when you are
cooking.
When you switch from setting 3 to setting 4 or higher,
▯
the burner will briefly switch to its maximum output.
This is to optimize ignition between the burner rings.
Do not cover the ventilation openings on the rear of
▯
the gas cooktop.
When the gas cooktop is switched on, the electronics
▯
open up the gas supply, which produces a short
sound. This is normal.
In the event of a power failure, the appliance will not
▯
work. The gas supply is shut off.