Comelit 3070 Serie Manuel Technique page 30

3. INFO
This procedure can be used to view:
• the firmware version
• the number of users stored [NOT VIP]
• the number of passwords stored
• the RS485 address [NOT VIP]
• the call mode
PROCEDURE DISPLAY INFO
Access configuration (see
MAIN
page 23).
INFO
Select the menu
Art. 3070x
INFO using the key.
1.1
Press the key to exit
the menu.
Exit configuration (see
page 23).
DATA MANAGEMENT USING 1249B (R.I. 003)
ENTERING A LIST (DOWNLOAD)
Software Art.1249B (R.I. 003 - SW rev. 2.3 or higher) can be used to enter the
list with Indirect Code and Code fields for INDIRECT CODE operating mode
on module 3070x. 3070x must be set to indirect code call mode (see "1.1.3.
Call mode").
INITIAL CONDITION
Module powered up in
ENTER
standby mode.
USER CODE
30
[NOT VIP]
DESCRIPTION
The menus are scrolled
through automatically
every 2 seconds.
[NOT VIP]
PROCEDURE DISPLAY INFO
Connect the cable
supplied with software
ENTER
Art. 1249B (R.I. 003) to
USER CODE
terminals TX / RX / - (or
D / D- if you have an
RS485 line).
Run software
Art. 1249B (R.I. 003).
ENTER
USER CODE
Make the list with the
Code and Indirect
ENTER
Code entries in
USER CODE
software Art. 1249B
with R.I. 003, or load an
existing list.
Press the
Download button in
software Art. 1249B
(R.I. 003).
DOWNLOADING...
COMPLETED
DOWNLOADING...
ABORTED
DESCRIPTION
On software 1249B
with R.I. 003, the CALL
MODE must be set as
Indirect Code
without a name entry.
If the download was
completed successfully.
or:
If an error occurred
during the download.