Publicité
Les langues disponibles
Les langues disponibles
ACCESSORIES
● Accessories other than those shown below
can lead to
injuries.
STANDARD ACCESSORIES
1
1 Safety glasses
2 Nose cap (mounted on tool)
3 Case
OPTIONAL ACCESSORIES ... sold separately
○ Single sequential actuation mechanism kit (Code No.
887916)
○ Pneumatic Tool Lubricant
1 oz. (30 cc) oil feeder
4 oz. (120 cc) oil feeder
1 quart (1 ltr) can
NOTE: Accessories are subject to change without any
obligation on the part of metabo HPT.
APPLICATIONS
○ Nailing as fi nishing process for areas around the
doors, windows as well as edgings.
○ Securing the bottom of drawers. Making various
cases and cabinets.
BEFORE OPERATION
Read section titled "SAFETY" (pages 4 – 8).
Make sure of the followings before operation.
WORKING ENVIRONMENT
● No fl ammable gas, liquid or other fl ammable
objects at worksite.
● Clear the area of children or unauthorized
personnel.
WARNING
malfunction and resulting
2
3
(Code No.877153)
(Code No.874042)
(Code No.876212)
WARNING
AIR SUPPLY
● Never connect Nailer to pressure which
potentially exceeds 200 psi (13.7 bar
14 kgf/cm
● Never use non relieving coupler on Nailer.
1. Power source
○ Use only clean, dry, regulated compressed air as a
1
power source for this Nailer.
1
○ Air compressors used to supply compressed air to
1
this Nailer must comply with the requirements of
the latest version of ANSI Standard B 19.3 "Safety
Standard For Compressors For Process Industries."
○ Moisture or oil in the air compressor may accelerate
wear and corrosion in the Nailer.
Drain daily.
2. Filter-Regulator-Lubricator
○ Use a regulator with a pressure range of 0 – 120 psi
(0 – 8.3 bar 0 – 8.5 kgf/cm
○ Filter-regulator-lubricator units supply an optimum
condition for the Nailer and extend the Nailer life.
These units should always be used.
Filter ............ The fi lter removes moisture and dirt
Regulator ..... The regulator controls the operating
Lubricator .... The lubricator supplies an oil mist to the
DANGER
● NEVER use reactive gases
or other bottled gases.
Explosion may occur.
WARNING
) if a regulator fails.
2
).
2
mixed in compressed air.
Drain daily unless fi tted with an
automatic drain.
Keep the fi lter clean by regular
maintenance.
pressure for safe operation of the Nailer.
Inspect the regulator before operation to
be sure it operates properly.
Nailer.
Inspect the lubricator before operation
to be sure the supply of lubricant is
adequate.
Use metabo HPT pneumatic tool lubricant.
English
11
Publicité
