Dell PowerEdge 1955 Guide De Configuration page 43

To remove password protection from your console:
1 In the Main dialog box, click Setup - Security.
2 Type your password, and then click OK.
3 In the Security dialog box, single-click and press <Enter> or double-click in the New box.
Leave the box blank. Press <Enter>.
4 Single-click and press <Enter> or double-click in the Repeat box. Leave the box blank.
Press <Enter>.
5 Click OK if you only want to eliminate your password.
To enable the screen saver mode with no password protection:
1 If your console does not require a password to gain access to the Security dialog box,
go to step 2.
- or -
If your console is password protected, see the previous procedure, then go to step 2.
2 Select Enable Screen Saver.
3 Type the number of minutes for delay time (from 1 to 99) that you want to delay activation
of the screen saver.
CAUTION:
Monitor damage can result from the use of Energy mode with monitors not compliant with
ENERGY STAR.
4 Choose Energy if your monitor is ENERGY STAR compliant; otherwise select Screen.
5 (Optional) Click Test to activate the screen saver test which lasts 10 seconds then returns you
to the Security dialog box.
6 Click OK.
NOTE:
Activation of the screen saver mode disconnects the server module.
To exit the screen saver mode:
Press any key or move your mouse.
To turn off the screen saver:
1 In the Security dialog box, clear Enable Screen Saver.
2 Click OK.
To immediately turn on the screen saver:
Press <Print Screen>, then press <Pause>.
NOTE:
Enable Screen Saver must be selected in the Security dialog box.
Configuring the KVM Switch Module
41