Garland 790 QG-V23 Manuel D'instructions page 39

The pieces of wood that might have got stuck
transversally must only be removed when the machine
has been stopped and the blades have stopped
rotating.
Transport of the machine should be carried out by two
persons to avoid possible injuries.
Two blades opposite on a rotor and another counter
blade on the chassis.
6.4.2. STARTING THE ENGINE
Before starting engine make sure check the engine oil
and fuel tank before starting the engine.
6.4.2.1. COLD-STARTING THE ENGINE
A. Place the ON/OFF switch in the "ON" position.
B. Place the fuel tap in the open position.
C. Place the air lever in the Closed position
D. Place the accelerator lever in the maximum
position .
E. Pull the starter grip until the engine starts up and
go past the air lever slowly to the OPEN position
(normal working position). Put the throttle lever
in the down position and let the engine warm for
1 minute before starting to work.
Normal working
position
6.4.2.2. WARM ENGINE START
Follow the A & B steps on the Cold engine start. Move
the throttle to middle position and pull the starter grip
until it starts.
6.4.2.3. STOP THE ENGINE
Move the throttle lever to the down position and the
. engine switch OFF. If you put the Shredder away,
move the lever to the passage of gasoline in the OFF
position.
7. MACHINE USAGE
Make sure the plastic cover over the hopper is closed
when the shredder is running. Splinter can jump and
be dangerous.
Do not put your face or hands in the hopper.
Keep your face and body away from the hopper.
39/124
Throttle level
Turtle = Minimum
Hare = Maximum
English